There was a mix of overrideable-in-overlays ```buildPackages.perl528``` & ```buildPackages.perldevel``` and local ```perl528``` & ```perldevel``` which were unaffected by overlays
give priority to perl libraries when they meet the perl derivation in `buildEnv`.
The notable case is `buildEnv` inside `perl.withPackages`.
The `perl' derivation includes obsolete versions of some CPAN packages
which leads to collissions when there are newer versions
of the same libraries are on the right hand side
of `perl.withPackages` (perhaps indirectly).
Fixes #60025
The only outside-curl uses of `fetchurlBoot` left are `stdenv`
and `apple-source-releases`. The latter one can probably be removed
too, but I can't test it.
Pros:
- Aggregates all behind-the-scenes insanity in a single place.
Cons:
- At the cost of 10 more derivations (but 0 new outpaths).
Perl likes to capture impure data, needlessly.
- Configure time (cf_time): make 1 second past epoch
- Target system (uname): use less uname information
Following legacy packing conventions, `isArm` was defined just for
32-bit ARM instruction set. This is confusing to non packagers though,
because Aarch64 is an ARM instruction set.
The official ARM overview for ARMv8[1] is surprisingly not confusing,
given the overall state of affairs for ARM naming conventions, and
offers us a solution. It divides the nomenclature into three levels:
```
ISA: ARMv8 {-A, -R, -M}
/ \
Mode: Aarch32 Aarch64
| / \
Encoding: A64 A32 T32
```
At the top is the overall v8 instruction set archicture. Second are the
two modes, defined by bitwidth but differing in other semantics too, and
buttom are the encodings, (hopefully?) isomorphic if they encode the
same mode.
The 32 bit encodings are mostly backwards compatible with previous
non-Thumb and Thumb encodings, and if so we can pun the mode names to
instead mean "sets of compatable or isomorphic encodings", and then
voilà we have nice names for 32-bit and 64-bit arm instruction sets
which do not use the word ARM so as to not confused either laymen or
experienced ARM packages.
[1]: https://developer.arm.com/products/architecture/a-profile
This involved:
* Installing miniperl as $dev/bin/perl
* Setting miniperl to take INC from
lib/perl5/{site_perl/,}cross_perl/${version} as well as
lib/perl5/{site_perl/,}/${version}/${runtimeArch}, in that
order. miniperl taking from runtimeArch is not really correct, but
it works in some pure-perl cases (e.g. Config.pm) and can be
overridden with the cross_perl variant.
* Installing perl-cross's stubs into
$dev/lib/perl5/cross_perl/${version}
* Patching MakeMaker.pm to gracefully degrade (very slightly) if B.pm
can't be loaded, which it can't in cross-compilation.
* Passing the right build-time and runtime perls to Makefile.PL
