I originally wanted to do this a long time (a31301d) but IIRC back then
it didn't compile. Nowadays with the splitup of the gold linking flags
and the binutils integration, it's merely just a switch to flip, so
let's do that.
Only tested it by building against the current Chromium stable version
on 64bit, because right now builds on Hydra seem to time out (because of
this?) anyway so we have nothing to lose here.
The linking time was hereby reduced from >30 minutes (I didn't measure
it exactly but looked half an hour later to the build progress and it
was *still* linking) to about a few seconds, which I guess is even
though the measurement is quite bogus a tremendous improvement
nonetheless.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
The openimageio dependency doesn't build on i686. But probably nobody
cares about running Blender on 32-bit anymore.
http://hydra.nixos.org/build/33602734
Note: the 1.2.9 GitHub tarball's sha256 has changed.
Changes:
- Fixed an issue introduced by the fix for 1196 that had the "Upload
to SD" button stop working correctly.
- Fixed an issue causing an error on disconnect after or cancelling of
an SD print, caused by the unsuccessful attempt to record print
recovery data for the file on the printer's SD card.
- Only add bed temperature line to temperature management specific
start gcode in CuraEngine invocation if a bed temperature is actually
set in the slicing profile.
- If a communication timeout occurs during an active resend request,
OctoPrint will now not send an M105 with an increased line number
anymore but repeat the last resent command instead.
- Don't add an extra ok for M28 response.
- Add an extra ok for M29 response, but only if configured such in
"Settings" > "Serial" > "Advanced options" > "Generate additional ok
for M29"
- Trigger M20 only once after finishing uploading to SD
- Prevent M105 "cascade" due to communication timeouts
- Fixed wrong tracking of extruder heating up for M109 Tn commands in
multi-extruder setups.
- Fixed start of SD file uploads not sending an M110.
- Fixed job data not being reset when disconnecting while printing.
